Skip to content

Country

Adafruit Stereo 3.7W Class D Audio Amplifier

SKU ADA-987
Sold out
Original price $11.00 (ex:Vat)
Original price $11.00 - Original price $11.00
Original price $11.00 (ex:Vat)
Current price $8.00
$8.00 - $8.00
Current price $8.00
(ex:Vat)
Availability:
Out of stock
Thanks for signing up for restock notifications!
There was an error signing up for restock notifications. Please try again.

Sign up for restock notifications

Notify Me
Request a quote
A small but surprisingly powerful stereo amplifier with selectable gain:
  • Delivers 2 x 3.7W channels in to 3 ohm impedance speakers
  • Class D controller able to run from 2.7V-5.5V DC
  • Incredibly efficient - over 90% efficient when driving an 8 ohm speaker at over a Watt
  • Output Power: 3.7W at 3?, 10% THD, 1.7W at 8?, 10% THD, with 5V Supply
  • Passes EMI limit unfiltered with up to 12 inches (30 cm) of speaker cable
  • High 83dB PSRR at 217Hz
  • Spread-Spectrum Modulation and Active Emissions Limiting
  • Five pin-selectable gains: 6dB, 9dB, 12dB, 15dB and 18dB. Select with a jumper or by setting the G and G' breakout pins (see the schematic for breakout board showing gain pin settings for details)
  • Excellent click-and-pop suppression
  • Thermal and short-circuit/over-current protection
  • Low current draw: 2mA quiescent and 10uA in shutdown mode
  • Dimensions - 23.28mm (l) x 24.15mm (w) x 3.03mm (h)
The inputs of the amplifier go through 1.0uF capacitors, so they are fully 'differential' - if you don't have differential outputs, simply tie the R- and L- to ground. The outputs are "Bridge Tied" - that means they connect directly to the outputs, no connection to ground. The output is a 360KHz square wave PWM that is then 'averaged out' by the speaker coil - the high frequencies are not heard. All the above means that you can't connect the output into another amplifier, it should drive the speakers directly.